Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 496

www.dell.com | support.dell.com SCP and SSH Secure shell (SSH) is a protocol for secure remote login and other secure network services over an insecure network. FTOS is compatible with SSH versions 1.5 and 2, both the client and server modes. SSH sessions are encrypted and use authentication. For information about command syntax, refer to the Security chapter in the FTOS Command Line Interface Reference Guide. Secure copy (SCP) is a remote file copy program that works with SSH and is supported by FTOS. Note: The Windows-based WinSCP client software is not supported for secure copying between a PC and an FTOS-based system. Unix-based SCP client software is supported. To use the SSH client, use the following command in EXEC Privilege mode: Command Syntax ssh {hostname} [-l username | -p port-number | -v {1 | 2} Command Mode EXEC Privilege Purpose Open an SSH connection specifying the hostname, username, port number, and version of the SSH client. • hostname is the IP address or hostname of the remote device. • Enter an IPv4 address in dotted decimal format (A.B.C.D). To enable the SSH server for version 1 and 2, use the following command in CONFIGURATION mode: Command Syntax ip ssh server {enable | port port-number} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SCP/ SSH server. To enable the SSH server for version 1 or 2 only, use the following command in CONFIGURATION mode: Command Syntax ip ssh server version {1|2} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SSH server that uses only version 1 or 2. To view the SSH configuration, use the following command in EXEC Privilege mode: Command Syntax show ip ssh Command Mode EXEC Privilege Purpose Display SSH connection information. Figure 28-8 shows the use of the ip ssh server version 2 command to enable SSH version 2, and the show ip ssh command to confirm the setting. 494 | Security