Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 442

www.dell.com | support.dell.com To add routes from other routing instances or protocols, use any of the following commands in ROUTER RIP mode: Command Syntax redistribute {connected | static} [metric metric-value] [route-map map-name] redistribute ospf process-id [match external {1 | 2} | match internal] [metric value] [route-map map-name] Command Mode Purpose ROUTER RIP ROUTER RIP Include directly connected or user-configured (static) routes in RIP. • metric range: 0 to 16 • map-name: name of a configured route map. Include specific OSPF routes in RIP. Configure the following parameters: • process-id range: 1 to 65535 • metric range: 0 to 16 • map-name: name of a configured route map. To view the current RIP configuration, use the show running-config command in EXEC mode or the show config command in ROUTER RIP mode. Set the Send and Receive Version To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other version, use the ip rip send version or the ip rip receive version commands in INTERFACE mode. To change the RIP version globally in FTOS, use the following command in ROUTER RIP mode: Command Syntax version {1 | 2} Command Mode Purpose ROUTER RIP Set the RIP version sent and received on the system. To set one RIP version globally, use the system command. This command sets the RIP version for RIP traffic on the interfaces participating in RIP, unless the interface was specifically configured for a specific RIP version. To see whether the version command is configured, use the show config command in ROUTER RIP mode. To view the routing protocols configuration, use the show ip protocols command in EXEC mode. 440 | Routing Information Protocol (RIP)