Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 228

www.dell.com | support.dell.com To assign an IP address, use the following commands in INTERFACE mode: Command Syntax no shutdown ip address ip-address mask [secondary] Command Mode INTERFACE INTERFACE Purpose Enable the interface. Configure a primary IP address and mask on the interface. The ip-address must be in dotted-decimal format (A.B.C.D) and the mask must be decimal and should be mentioned in slash format (/xx). Add the keyword secondary if the IP address is the interface's backup IP address. You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP addresses on a single interface. To view all interfaces with an IP address assigned, use the show ip interfaces brief command in EXEC mode. To view IP information on an interface in Layer 3 mode, use the show ip interface command in EXEC Privilege mode (Figure 13-7). Figure 13-7. show ip interface Command Example FTOS(conf-if-vl-10)#do sh int vl 10 Vlan 10 is up, line protocol is up Address is 00:1e:c9:f1:03:38, Current address is 00:1e:c9:f1:03:38 Interface index is 1107787786 Internet address is 5.5.5.1/24 Mode of IP Address Assignment : MANUAL DHCP Client-ID: vlan10001ec9f10338 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:01:09 Queueing strategy: fifo Time since last interface status change: 00:00:46 Management Interfaces The IOM management interface has both a public IP and private IP address on the internal Fabric D interface. The public IP address is exposed to the outside world for Web GUI configurations/WSMAN and other proprietary traffic. You can statically configure the public IP address or obtain the IP address dynamically using the dynamic host configuration protocol (DHCP). Note: When you shut down a management interface, connectivity to the interface's private IP address is disabled. 226 | Interfaces