Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 641

Figure 38-6 shows the same VRRP group configured on multiple interfaces on different subnets. Figure 38-6. show vrrp Command Example FTOS#do show vrrp Same VRRP Group (VRID) Tengigabitethernet 1/1, VRID: 111, Net: 10.10.10.1 State: Master, Priority: 255, Master: 10.10.10.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 1768, Gratuitous ARP sent: 5 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.10.1 10.10.10.2 10.10.10.3 10.10.10.10 Authentication: (none) Tengigabitethernet 1/2, VRID: 111, Net: 10.10.2.1 State: Master, Priority: 100, Master: 10.10.2.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 27, Gratuitous ARP sent: 2 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.2.2 10.10.2.3 Authentication: (none) FTOS# Different Virtual IP addresses When the VRRP process completes its initialization, the State field contains either Master or Backup. Set the VRRP Group (Virtual Router) Priority Setting a virtual router priority to 255 ensures that router is the OWNER virtual router for the VRRP group. VRRP elects the MASTER router by choosing the router with the highest priority. The default priority for a virtual router is 100. The higher the number, the higher the priority. If the MASTER router fails, VRRP begins the election process to choose a new MASTER router based on the next-highest priority. Note: Configuring VRRP priority 255 on an interface on which DHCP Client is enabled is not supported. If two routers in a VRRP group come up at the same time and have the same priority value, the interface's physical IP addresses are used as tie-breakers to decide which is MASTER. The router with the higher IP address will become MASTER. Virtual Router Redundancy Protocol (VRRP) | 639