Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 96

www.dell.com | support.dell.com You can create multiple instances of this route map using the sequence number option to place the route maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, such as redistribute, traffic passes through all instances of that route map until a match is found. Figure 5-24 shows an example with two instances of a route map. Figure 5-24. Command Example: show route-map with Multiple Instances of a Route Map FTOS#show route-map route-map zakho, permit, sequence 10 Match clauses: Set clauses: route-map zakho, permit, sequence 20 Match clauses: interface TenGigabitEthernet 0/1 Set clauses: tag 35 level stub-area FTOS# Route map zakho has two instances To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax (Figure 5-25). Figure 5-25. Deleting One Instance of a Route Map FTOS(conf)#no route-map zakho 10 FTOS(conf)#end FTOS#show route-map route-map zakho, permit, sequence 20 Match clauses: interface TenGigabitEthernet 0/1 Set clauses: tag 35 level stub-area FTOS# Figure 5-26 shows an example of a route map with multiple instances. The show config command displays only the configuration of the current route map instance. To view all instances of a specific route map, use the show route-map command. Figure 5-26. Command Example: show route-map FTOS#show route-map dilling route-map dilling, permit, sequence 10 Match clauses: Set clauses: route-map dilling, permit, sequence 15 Match clauses: interface Loopback 23 Set clauses: tag 3444 FTOS# To delete a route map, use the no route-map map-name command in CONFIGURATION mode. 94 | Access Control Lists (ACLs)