Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 642

www.dell.com | support.dell.com To configure the VRRP group's priority, use the following command: Task Configure the priority for the VRRP group. Range: 1 to 255 Default: 100 Command Syntax priority priority Figure 38-7. priority Command Example FTOS(conf-if-te-1/2)#vrrp-group 111 FTOS(conf-if-te-1/2-vrid-111)#priority 125 Command Mode INTERFACE -VRID Figure 38-8. show vrrp Command Example FTOS#show vrrp Tengigabitethernet 1/1, VRID: 111, Net: 10.10.10.1 State: Master, Priority: 255, Master: 10.10.10.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 2343, Gratuitous ARP sent: 5 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.10.1 10.10.10.2 10.10.10.3 10.10.10.10 Authentication: (none Tengigabitethernet 1/2, VRID: 111, Net: 10.10.2.1 State: Master, Priority: 125, Master: 10.10.2.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 601, Gratuitous ARP sent: 2 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.2.2 10.10.2.3 Authentication: (none) FTOS(conf)# Configure VRRP Authentication Simple authentication of VRRP packets ensures that only trusted routers participate in VRRP processes. When you enable authentication, FTOS includes the password in its VRRP transmission, and the receiving router uses that password to verify the transmission. Note: You must configure all virtual routers in the VRRP group at the same: authentication must be enabled with the same password or authentication is disabled. 640 | Virtual Router Redundancy Protocol (VRRP)