Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 562

www.dell.com | support.dell.com Reset a Unit on a Stack Use the following reset commands to reload any of the member units or the standby in a stack. If you try to reset the stack master, an error message is displayed: Reset of master unit is not allowed. Task Reload a stack unit from the master switch Reload a member unit from the unit itself. Reset a stack-unit when the unit is in a problem state. Command Syntax reset stack-unit unit-number reset-self reset stack-unit unit-number hard Command Mode EXEC Privilege EXEC Privilege EXEC Privilege Verifying a Stack Configuration Using LEDs Table 31-1 lists the status of a stacked switch according to the color of the System Status light emitting diodes (LEDs) on its front panel. Table 31-1. System Status LED on a Stacked Switch Color Meaning Blue The switch is operating as the stack master or as a standalone unit. Off The switch is a member or standby unit. Amber The switch is booting or a failure condition has occurred. Using Show Commands To display information on the stack configuration, use the show commands in Table 31-2 on the master switch. Table 31-2. Displaying Stack Configurations Command Output show system [brief] (Figure 31-8 and Figure 31-9) show inventory optional-module (Figure 31-10) show system stack-unit unit-number stack-group configured (Figure 31-11) show system stack-unit unit-number stack-group (Figure 31-12) Displays stacking roles (master, standby, and member units) and the stack MAC address. Displays the FlexIO modules currently installed in expansion slots 0 and 1 on a switch and the expected module logically provisioned for the slot. Displays the stack groups allocated on a stacked switch. Valid stack-unit numbers: 0 to 5. Displays the port numbers that correspond to the stack groups on a switch. Valid stack-unit numbers: 0 to 5. 560 | Stacking