Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 646

www.dell.com | support.dell.com You can configure a tracked object for a VRRP group (using the track object-id command in INTERFACE-VRID mode) before you actually create the tracked object (using a track object-id command in CONFIGURATION mode) (Figure 38-15) and (Figure 38-16). However, no changes in the VRRP group's priority occur until the tracked object is defined and determined to be down. To track an interface, use the following commands in VRRP mode: Task Command Syntax Monitor an interface and, optionally, set a value to be subtracted from the interface's VRRP group priority. Cost Range: 1-254 Default: 10 (Optional) Display the configuration and UP or DOWN state of tracked objects, including the client (VRRP group) that is tracking an object's state. (Optional) Display the configuration and UP or DOWN state of tracked interfaces and objects in VRRP groups, including the time since the last change in an object's state. (Optional) Display the configuration of tracked objects in VRRP groups on a specified interface. track interface [priority-cost cost] show track show vrrp show running-config interface interface Command Mode INTERFACE-VRID EXEC EXEC Privilege EXEC EXEC Privilege EXEC EXEC Privilege The sum of all the costs for all tracked interfaces must be less than the configured priority of the VRRP group. Figure 38-15. track Command Example FTOS(conf-if-te-1/1)#vrrp-group 111 FTOS(conf-if-te-1/1-vrid-111)#track tengigabitethernet 1/2 FTOS(conf-if-te-1/1-vrid-111)# Figure 38-16. track Command Example (VRID mode) FTOS(conf-if-te-1/1-vrid-111)#show conf ! vrrp-group 111 advertise-interval 10 authentication-type simple 7 387a7f2df5969da4 no preempt priority 255 track Tengigabitethernet 1/2 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 virtual-address 10.10.10.10 FTOS(conf-if-te-1/1-vrid-111)# 644 | Virtual Router Redundancy Protocol (VRRP)