Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 56

www.dell.com | support.dell.com Figure 4-1. Create a Custom Privilege Level Apply a Privilege Level to a Username FTOS(conf)#do show run privilege ! FTOS(conf)#privilege exec level 3 capture FTOS(conf)#privilege exec level 3 configure FTOS(conf)#privilege exec level 4 resequence FTOS(conf)#privilege exec level 3 clear arp-cache FTOS(conf)#privilege exec level 3 clear arp-cache max-buffer-size FTOS(conf)#privilege configure level 3 line FTOS(conf)#privilege configure level 3 interface FTOS(conf)#do telnet 10.11.80.201 [telnet output omitted] FTOS#show priv Current privilege level is 3. FTOS#? capture Capture packet configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC ip Global IP subcommands monitor Monitoring feature mtrace Trace reverse multicast path from destination to source ping Send echo messages quit Exit from the EXEC show Show running system information [output omitted] FTOS#config [output omitted] FTOS(conf)#do show priv Current privilege level is 3. FTOS(conf)#? end Exit from configuration mode exit Exit from configuration mode interface Select an interface to configure FTOS(conf)#interface ? loopback Loopback interface managementethernet Management Ethernet interface null Null interface port-channel Port-channel interface range Configure interface range tengigabitethernet TenGigabit Ethernet interface vlan VLAN interface FTOS(conf)#interface tengigabitethernet 1/1 FTOS(conf-if-te-1/1)#? end Exit from configuration mode exit Exit from interface configuration mode FTOS(conf-if-te-1/1)#exit FTOS(conf)#line ? console Primary terminal line vty Virtual terminal FTOS(conf)#line vty 0 FTOS(conf-line-vty)#? exit Exit from line configuration mode FTOS(conf-line-vty)# 54 | Management