Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 647

Figure 38-17. show vrrp Command Example FTOS#show vrrp TenGigabitEthernet 1/3, IPv4 VRID: 21, Version: 2, Net: 10.1.1.1 State: Master, Priority: 100, Master: 10.1.1.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 72, Gratuitous ARP sent: 1 Virtual MAC address: 00:00:5e:00:01:15 Virtual IP address: 10.1.1.2 Authentication: (none) FTOS# Figure 38-18. show running-config interface Command Example FTOS#show running-config interface tengigabitethernet 1/3 ! interface TenGigabitEthernet 1/3 ip address 10.1.1.1/24 ! vrrp-group 21 virtual-address 10.1.1.2 no shutdown FTOS# VRRP Initialization Delay When configured, VRRP is enabled immediately upon system reload or boot. VRRP initialization can be delayed to allow IGP and EGP protocols to be enabled prior to selecting the VRRP MASTER. This delay ensures that VRRP initializes with no errors or conflicts. You can configure the delay for up to 15 minutes, after which VRRP enables normally. The delay timer is set on individual interfaces and is supported on all physical interfaces, VLANS, and link aggregation groups (LAGs). When you configure both CLIs, the later timer rules the VRRP enabling. For example, if you configure vrrp delay reload 600 and vrrp delay minimum 300, the following behavior occurs: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for vrrp. • When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Virtual Router Redundancy Protocol (VRRP) | 645