Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 324

www.dell.com | support.dell.com Figure 18-7. Configuration and Interface mode LLDP Commands R1(conf)#protocol lldp R1(conf-lldp)#? advertise Advertise TLVs dcbx Configure Dcbx Parameters disable Disable LLDP protocol globally end Exit from configuration mode exit Exit from LLDP configuration mode fcoe Configure priority bits for FCoE traffic hello LLDP hello configuration iscsi Configure priority bits for ISCSI traffic mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-lldp)#exit R1(conf)#interface tengigabitethernet 1/31 R1(conf-if-te-1/31)#protocol lldp R1(conf-if-te-1/31-lldp)#? advertise Advertise TLVs dcbx Configure Dcbx Parameters disable Disable LLDP protocol on this interface end Exit from configuration mode exit Exit from LLDP configuration mode hello LLDP hello configuration mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-if-te-1/31-lldp)# Enabling LLDP LLDP is disabled by default. You can enable and disable LLDP globally or per interface. If you enable LLDP globally, all up interfaces send periodic LLDPDUs. To enable LLDP, follow these steps: Step 1 2 Task Enter Protocol LLDP mode. Enable LLDP. Command protocol lldp no disable Command Mode CONFIGURATION or INTERFACE PROTOCOL LLDP Disabling and Undoing LLDP • Disable LLDP globally or for an interface using the disable command. • Undo an LLDP configuration by preceding the relevant command with the keyword no command. 322 | Link Layer Discovery Protocol (LLDP)