Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 79

Figure 5-6. Command Example: show ip accounting access-list FTOS#show ip accounting access ToOspf interface tengig 1/6 Standard IP access list ToOspf seq 5 deny any seq 10 deny 10.2.0.0 /16 seq 15 deny 10.3.0.0 /16 seq 20 deny 10.4.0.0 /16 seq 25 deny 10.5.0.0 /16 seq 30 deny 10.6.0.0 /16 seq 35 deny 10.7.0.0 /16 seq 40 deny 10.8.0.0 /16 seq 45 deny 10.9.0.0 /16 seq 50 deny 10.10.0.0 /16 FTOS# Figure 5-7 shows how the seq command orders the filters according to the sequence number assigned. In the example, filter 25 was configured before filter 15, but the show config command displays the filters in the correct order. Figure 5-7. Command example: seq FTOS(conf-std-nacl)#seq 25 deny ip host 10.5.0.0 any FTOS(conf-std-nacl)#seq 15 permit tcp 10.3.0.0 /16 any FTOS(conf-std-nacl)#show config ! ip access-list standard dilling seq 15 permit tcp 10.3.0.0/16 any FTOS(conf-std-nacl)# To delete a filter, use the no seq sequence-number command in IP ACCESS LIST mode. If you are creating a standard ACL with only one or two filters, you can let FTOS assign a sequence number based on the order in which the filters are configured. The software assigns filters in multiples of 5. To configure a filter without a specified sequence number, follow these steps starting in CONFIGURATION mode: Step Command Syntax Command Mode 1 ip access-list standard access-list-name CONFIGURATION 2 {deny | permit} {source [mask] | any | host ip-address} [count [byte]] [order] [fragments] CONFIG-STD-NACL Purpose Create a standard IP ACL and assign it a unique name. Configure a drop or forward IP ACL filter. Access Control Lists (ACLs) | 77