Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 268

www.dell.com | support.dell.com Command Syntax traceroute [host | ip-address ] Command Mode CONFIGURATION Purpose When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are prompted for: • a target and source IP address • timeout in seconds (default is 5) • a probe count (default is 3) • minimum TTL (default is 1) • maximum TTL (default is 30) • port number (default is 33434). To keep the default setting for those parameters, press the ENTER key. Figure 14-6 shows an example output of DNS using the traceroute command. Figure 14-6. Traceroute Command Example FTOS#traceroute www.force10networks.com Translating "www.force10networks.com"...domain server (10.11.0.1) [OK] Type Ctrl-C to abort. Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte packets TTL Hostname Probe1 Probe2 Probe3 1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms 2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms 001.000 ms 001.000 ms 3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000 ms 4 www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms FTOS# Addess Resolution Protocol (ARP) FTOS uses two forms of address resolution: ARP and proxy ARP. ARP runs over Ethernet and enables endstations to learn the MAC addresses of neighbors on an IP network. Over time, FTOS creates a forwarding table mapping the MAC addresses to their corresponding IP address. This table is called ARP cache. Dynamically learned addresses are removed after a defined period of time. For more information about ARP, refer to RFC 826, An Ethernet Address Resolution Protocol. 266 | IPv4 Routing