Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 648

www.dell.com | support.dell.com Task Command Syntax Set the delay time for VRRP initialization on an individual interface. This is the gap between an interface coming up and being operational, and VRRP enabling. Seconds range: 0-900 Default: 0 vrrp delay minimum seconds Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP. This is the gap between system boot up completion and VRRP enabling. Seconds range: 0-900 Default: 0 vrrp delay reload seconds Command Mode INTERFACE INTERFACE Sample Configurations VRRP for IPv4 Configuration The configuration in Figure 38-19 shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your own IP addresses, interfaces, names, etc. Figure 38-19 shows the VRRP topology created with the CLI configuration in Figure 38-20. 646 | Virtual Router Redundancy Protocol (VRRP)