Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 54

www.dell.com | support.dell.com Removing a Command from EXEC Mode Remove a command from the list of available commands in EXEC mode for a specific privilege level using the privilege exec command from CONFIGURATION mode. In the command, specify a level greater than the level given to a user or terminal line, followed by the first keyword of each command to be restricted. Move a Command from EXEC Privilege Mode to EXEC Mode Move a command from EXEC Privilege to EXEC mode for a privilege level using the privilege exec command from CONFIGURATION mode. In the command, specify the privilege level of the user or terminal line, and specify all keywords in the command to which you want to allow access. Allow Access to CONFIGURATION Mode Commands Allow access to CONFIGURATION mode using the privilege exec configure level level command from CONFIGURATION mode. A user that enters CONFIGURATION mode remains at the same privilege level and has access to only two commands, end and exit. You must individually specify each CONFIGURATION mode command to which you want to allow access using the privilege configure level level command. In this command, specify the privilege level of the user or terminal line, and specify all keywords in the command to which you want to allow access. Allow Access to INTERFACE, LINE, ROUTE-MAP, and ROUTER Mode To allow access to INTERFACE, LINE, ROUTE-MAP, and ROUTER mode, follow these steps: 1. Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-MAP, and ROUTER modes, you must first allow access to the command that enters you into the mode. For example, allow a user to enter INTERFACE mode using the privilege configure level level interface tengigabitethernet command. 2. Then, individually identify the INTERFACE, LINE, ROUTE-MAP, or ROUTER commands to which you want to allow access using the privilege {interface | line | route-map | router} level level command. In this command, specify the privilege level of the user or terminal line, and specify all keywords in the command to which you want to allow access. The following table lists the configuration tasks you can use to customize a privilege level: Task Command Syntax Command Mode Remove a command from the list of available commands privilege exec level level in EXEC mode. {command ||...|| command} CONFIGURATION Move a command from EXEC Privilege to EXEC mode. Allow access to CONFIGURATION mode. privilege exec level level {command ||...|| command} privilege exec configure level level CONFIGURATION CONFIGURATION 52 | Management