Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 370

www.dell.com | support.dell.com Figure 20-8. show ip ospf process id Command Example FTOS#show ip ospf 55555 Routing Process ospf 55555 with ID 10.10.10.10 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 FTOS# Enable Multi-Process OSPF Multi-process OSPF allows multiple OSPFv2 processes on a single router. The following list shows the number of processes supported on each platform type. • The MXL Switch supports up to 16 OSPFv2 processes. When configuring a single OSPF process, follow the same steps described above. Repeat them as often as necessary for the desired number of processes. After you create the process, all other configurations apply as usual, To enable multi-process OSPF, follow these steps: Step Command Syntax 1 ip address ip-address mask 2 no shutdown Command Mode Usage CONFIG-INTERFACE Assign an IP address to an interface. Format: A.B.C.D/M If using a loopback interface, refer to Loopback Interfaces. CONFIG-INTERFACE Enable the interface. To enable the OSPF process, return to CONFIGURATION mode. The OSPF process ID is the identifying number assigned to the OSPF process. The Router ID is the IP address associated with the OSPF process. Command Syntax router ospf process-id Command Mode CONFIGURATION Usage Enable the OSPFv2 process globally. Range: 1-65535 If you try to enable more OSPF processes than available Layer 3 interfaces, you will see the following message. Message 4 FTOS(conf)#router ospf 1 % Error: No router ID available. 368 | Open Shortest Path First (OSPFv2)