HP Integrity rx2800 HP Insight Management WBEM Provider Events Reference Guide - Page 24
DIMM number not found in DMT Table. Probable Cause: Probable internal FW error.
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
5156 5157 5158 5159 5160 5161 5171 5172 5173 5174 5175 5176 5179 5180 Error Error Error Warning Warning Warning Warning Warning Warning Warning Warning Warning Warning Warning Failed to find lmmio entry in mdt. Probable Cause: The MDT table is bad because it did not have an LMMIO entry in it. Recommended Action: Reboot, if problem persists contact your HP representative for support. WBEM EventID: 294. WBEM ProviderName: FPL_IndicationProvider. Memory page zero bad. Probable Cause: Memory page 0 was slated for deallocation in the PDT. Recommended Action: FW is written such that this event should never be generated. If the user sees this event, please contact HP support. WBEM EventID: 295. WBEM ProviderName: FPL_IndicationProvider. Failed to find space in mdt. Probable Cause: FW requested an entry in the MDT, and there wasn't a large enough chunk of contiguous memory for the requested size. Recommended Action: Reboot, if problem persists contact your HP representative for support. WBEM EventID: 296. WBEM ProviderName: FPL_IndicationProvider. Media failure: info was not retrieved/logged. Probable Cause: The Error handler has failed to retrieve or log data due to a media failure. Recommended Action: Reboot if necessary, if problem persists contact your HP representative for support. WBEM EventID: 297. WBEM ProviderName: FPL_IndicationProvider. Bus interface register test failed. Probable Cause: The CEC failed the register test. Recommended Action: Contact HP support to troubleshoot the problem. WBEM EventID: 298. WBEM ProviderName: FPL_IndicationProvider. Memory ECC normal write/read test failed. Probable Cause: The DIMM that maps to address 0 is not seated properly. Recommended Action: Check all of the DIMMs in the system and make sure that they are inserted fully into the slot with the retention mechanism in place. WBEM EventID: 299. WBEM ProviderName: FPL_IndicationProvider. DIMM loading order error: DIMM deallocated. Probable Cause: A required DIMM is not loaded in order to allow for proper operation of the DIMM specified in the physical location. Recommended Action: Refer to the user's manual for Memory loading instructions. WBEM EventID: 300. WBEM ProviderName: FPL_IndicationProvider. DIMM SPD checksum failed. Probable Cause: The DIMMs SPD EEPROM got corrupted. Recommended Action: Contact HP Support personnel to troubleshoot the problem. WBEM EventID: 301. WBEM ProviderName: FPL_IndicationProvider. DIMM SPD fatal error. Probable Cause: Detection of SPD error type - various types. Recommended Action: Reseat or replace the DIMM. If problem persists, contact HP Support personnel to troubleshoot the problem. WBEM EventID: 302. WBEM ProviderName: FPL_IndicationProvider. Unsupported memory DIMM type. Probable Cause: A DIMM with an invalid DIMM type was found. Recommended Action: Contact HP Support personnel to troubleshoot the problem. WBEM EventID: 303. WBEM ProviderName: FPL_IndicationProvider. The DIMM type of this DIMM doesn't match with others in the DIMM group. Probable Cause: The DIMMs in the rank do not have the same DIMM type. Recommended Action: Contact HP Support personnel to troubleshoot the problem. WBEM EventID: 304. WBEM ProviderName: FPL_IndicationProvider. The DIMM type table is full. New DIMM type cannot be added. Probable Cause: Too many different types of DIMMs in system. Recommended Action: Reduce the number of different types of DIMMs in the system. WBEM EventID: 305. WBEM ProviderName: FPL_IndicationProvider. DIMM number not found in DMT Table. Probable Cause: Probable internal FW error. Recommended Action: Reload System Firmware. Recommended Action: Contact HP Support personnel to troubleshoot the problem. WBEM EventID: 306. WBEM ProviderName: FPL_IndicationProvider. Memory ECC multiple-bit data error detection failed. Probable Cause: The CEC failed MBE detection. Recommended Action: Contact HP support personnel to troubleshoot the problem. WBEM EventID: 307. WBEM ProviderName: FPL_IndicationProvider. 24 WBEM Provider Event Tables