HP Integrity rx2800 HP Insight Management WBEM Provider Events Reference Guide - Page 42

Recommended Action: Reset BMC or reboot. Upgrade BMC FW and System FW. If

Get HP Integrity rx2800 - i2 PDF manuals and user guides View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

5806 5807 5808 5809 5810 5811 5812 5813 5823 5824 5827 5832 5833 5834 5836 5837 Error Error Error Error Error Warning Warning Error Warning Error Warning Warning Warning Warning Warning Warning An unexpected neighbor type was read from a XBC PORT_NEIGHBOR_INFO CSR. Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset cell. WBEM EventID: 539. WBEM ProviderName: FPL_IndicationProvider. A given XBC port is not a valid XBC-CC port. Probable Cause: Firmware error. Recommended Action: Reset cell. WBEM EventID: 540. WBEM ProviderName: FPL_IndicationProvider. A XBC port was unexpectedly found to be an invalid XBC-XBC port. Probable Cause: Firmware error. Recommended Action: Reset cell. WBEM EventID: 541. WBEM ProviderName: FPL_IndicationProvider. The XBC neighbor chip number does not match the expected value for this topology. Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset cell. WBEM EventID: 542. WBEM ProviderName: FPL_IndicationProvider. The XBC neighbor port number does not match the expected value for this topology. Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset cell. WBEM EventID: 543. WBEM ProviderName: FPL_IndicationProvider. Write through to BMC token failed. Probable Cause: Problem accessing the BMC. Recommended Action: Reset BMC or reboot. Upgrade BMC FW and System FW. If problem persists, contact your HP representative for support. WBEM EventID: 544. WBEM ProviderName: FPL_IndicationProvider. Utilities reported an error while trying to manipulate the LED. Probable Cause: It is likely the GSP is not present or the device specified is not present. Solve these problems and try again. WBEM EventID: 2465. WBEM ProviderName: FPL_IndicationProvider. Duplicate Cpu Ids were detected within a cell. Probable Cause: Most likely cause is a bad cpu module connection on the cell board. Replace the cell board. WBEM EventID: 546. WBEM ProviderName: FPL_IndicationProvider. OS crashdump started (D700). Probable Cause: panic occurred. WBEM EventID: 547. WBEM ProviderName: FPL_IndicationProvider. OS legacy PA hex fault code (Bxxx). Probable Cause: fault/panic. WBEM EventID: 548. WBEM ProviderName: FPL_IndicationProvider. Setting processor response timeout failed. Probable Cause: A PAL call made by SFW has failed. Recommended Action: Reboot if necessary, if problem persists contact your HP representative for support. WBEM EventID: 550. WBEM ProviderName: FPL_IndicationProvider. Unable to validate blank password during EFI security initialization. Probable Cause: SAL failed. Recommended Action: Reset the system. Upgrade system firmware. If problem persists, contact HP support to troubleshoot the problem. WBEM EventID: 551. WBEM ProviderName: FPL_IndicationProvider. Unable to enter Guest mode during EFI security initialization. Probable Cause: BMC failure. Recommended Action: Reset the BMC. Update BMC FW. Contact your HP representative to check the BMC. WBEM EventID: 552. WBEM ProviderName: FPL_IndicationProvider. Unable to increase privilege during EFI security initialization. Probable Cause: SAL failure. Recommended Action: Reset the system. Upgrade system firmware. If problem persists, contact HP support to troubleshoot the problem. WBEM EventID: 553. WBEM ProviderName: FPL_IndicationProvider. EFI unable to write privilege level during security initialization. Probable Cause: SAL failure. Recommended Action: Reboot the system. Update SFW. If problem persists, contact HP support to troubleshoot the problem. WBEM EventID: 554. WBEM ProviderName: FPL_IndicationProvider. EFI was denied permission to write the privilege level during security init. Probable Cause: SAL is not in ADMIN or USER mode. Recommended Action: Reboot the system. Upgrade system firmware. If problem persists, contact HP support to troubleshoot the problem. WBEM EventID: 555. WBEM ProviderName: FPL_IndicationProvider. 42 WBEM Provider Event Tables

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
An unexpected neighbor type was read from a XBC PORT_NEIGHBOR_INFO CSR.
Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset
cell. WBEM EventID: 539. WBEM ProviderName: FPL_IndicationProvider.
Error
5806
A given XBC port is not a valid XBC-CC port. Probable Cause: Firmware error.
Recommended Action: Reset cell. WBEM EventID: 540. WBEM ProviderName:
FPL_IndicationProvider.
Error
5807
A XBC port was unexpectedly found to be an invalid XBC-XBC port. Probable Cause:
Firmware error. Recommended Action: Reset cell. WBEM EventID: 541. WBEM
ProviderName: FPL_IndicationProvider.
Error
5808
The XBC neighbor chip number does not match the expected value for this topology.
Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset
cell. WBEM EventID: 542. WBEM ProviderName: FPL_IndicationProvider.
Error
5809
The XBC neighbor port number does not match the expected value for this topology.
Probable Cause: Bad connection between XBC and cell. Recommended Action: Reset
cell. WBEM EventID: 543. WBEM ProviderName: FPL_IndicationProvider.
Error
5810
Write through to BMC token failed. Probable Cause: Problem accessing the BMC.
Recommended Action: Reset BMC or reboot. Upgrade BMC FW and System FW. If
problem persists, contact your HP representative for support. WBEM EventID: 544.
WBEM ProviderName: FPL_IndicationProvider.
Warning
5811
Utilities reported an error while trying to manipulate the LED. Probable Cause: It is
likely the GSP is not present or the device specified is not present. Solve these
problems and try again. WBEM EventID: 2465. WBEM ProviderName:
FPL_IndicationProvider.
Warning
5812
Duplicate Cpu Ids were detected within a cell. Probable Cause: Most likely cause is
a bad cpu module connection on the cell board. Replace the cell board. WBEM
EventID: 546. WBEM ProviderName: FPL_IndicationProvider.
Error
5813
OS crashdump started (D700). Probable Cause: panic occurred. WBEM EventID: 547.
WBEM ProviderName: FPL_IndicationProvider.
Warning
5823
OS legacy PA hex fault code (Bxxx). Probable Cause: fault/panic. WBEM EventID:
548. WBEM ProviderName: FPL_IndicationProvider.
Error
5824
Setting processor response timeout failed. Probable Cause: A PAL call made by SFW
has failed. Recommended Action: Reboot if necessary, if problem persists contact
your HP representative for support. WBEM EventID: 550. WBEM ProviderName:
FPL_IndicationProvider.
Warning
5827
Unable to validate blank password during EFI security initialization. Probable Cause:
SAL failed. Recommended Action: Reset the system. Upgrade system firmware. If
problem persists, contact HP support to troubleshoot the problem. WBEM EventID:
551. WBEM ProviderName: FPL_IndicationProvider.
Warning
5832
Unable to enter Guest mode during EFI security initialization. Probable Cause: BMC
failure. Recommended Action: Reset the BMC. Update BMC FW. Contact your HP
representative to check the BMC. WBEM EventID: 552. WBEM ProviderName:
FPL_IndicationProvider.
Warning
5833
Unable to increase privilege during EFI security initialization. Probable Cause: SAL
failure. Recommended Action: Reset the system. Upgrade system firmware. If problem
persists, contact HP support to troubleshoot the problem. WBEM EventID: 553.
WBEM ProviderName: FPL_IndicationProvider.
Warning
5834
EFI unable to write privilege level during security initialization. Probable Cause:
SAL failure. Recommended Action: Reboot the system. Update SFW. If problem
persists, contact HP support to troubleshoot the problem. WBEM EventID: 554.
WBEM ProviderName: FPL_IndicationProvider.
Warning
5836
EFI was denied permission to write the privilege level during security init. Probable
Cause: SAL is not in ADMIN or USER mode. Recommended Action: Reboot the
system. Upgrade system firmware. If problem persists, contact HP support to
troubleshoot the problem. WBEM EventID: 555. WBEM ProviderName:
FPL_IndicationProvider.
Warning
5837
42
WBEM Provider Event Tables