HP Integrity rx2800 HP Insight Management WBEM Provider Events Reference Guide - Page 82
Action: Collect IPMI Event Logs and contact your HP Service Representative
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
11972 Warning 11974 Warning 11989 Warning 12001 Error 12008 Warning 12013 Warning 12017 Error 12025 Warning 12028 Warning 12029 Warning 12047 Error 12048 Warning MCA during init event processing. Probable Cause: An MCA event happening before a previous INIT event was not completely processed. Recommended Action: For Fpars/Vpars, system FW will reset the hard partition. In Npars mode, MCA handler will attempt to hand off to OS_MCA handler. If handoff fails, the hard partition will be reset. WBEM EventID: 5181. WBEM ProviderName: FPL_IndicationProvider. unable to find a bad edge in an untraversable route. Probable Cause: The bad edge could not be found. Recommended Action: Check for intermittent link errors. Capture IPMI event logs and look for additional error events. Contact your HP Support Representative to investigate the fabric. WBEM EventID: 5182. WBEM ProviderName: FPL_IndicationProvider. Unknown entity drawing power from bus bars. WBEM EventID: 5183. WBEM ProviderName: FPL_IndicationProvider. Soft partition could not be booted, reverting to nPars. Probable Cause: A soft partition could not be booted. Please refer to previous events for the complete details. Recommended Action: The partition is rebooted to nPars to allow the soft partition to be re-configured. WBEM EventID: 5184. WBEM ProviderName: FPL_IndicationProvider. Unable to route around broken link. Probable Cause: A traversable route between the local cell and the specified destination crossbar could not be found. Recommended Action: Capture IPMI event logs. Contact your HP Support Representative to investigate the fabric subsystem. WBEM EventID: 5187. WBEM ProviderName: FPL_IndicationProvider. Unable to set the APER 'fabric lockdown' bit. Probable Cause: Internal FW error. Recommended Action: Reset partition. WBEM EventID: 5188. WBEM ProviderName: FPL_IndicationProvider. An uncorrectable memory ECC error has occurred. The data field gives the physical location of the DIMM that had the error. Probable Cause: An uncorrectable memory ECC error has occurred. Recommended Action: Replace all DIMMs in the memory rank specified in the physical location info. If problem persists, contact HP support to troubleshoot the problem. WBEM EventID: 6860. WBEM ProviderName: FPL_IndicationProvider. An error encountered while retrieving the expected neighbor fabric chip for distributing traffic over crossbar links. Probable Cause: Unexpected error retrieving information from the fabric graph. Recommended Action: Collect IPMI event logs and contact your HP Support Representative to investigate the fabric system firmware subsystem. WBEM EventID: 5189. WBEM ProviderName: FPL_IndicationProvider. Could not read crossbar neighbor information during routing. Probable Cause: System Firmware encountered an error while reading a fabric crossbar chip. Recommended Action: Collect IPMI Event Logs and contact your HP Service Representative to investigate the fabric subsystem. WBEM EventID: 5190. WBEM ProviderName: FPL_IndicationProvider. Could not establish route for local crossbar during route around routing. Probable Cause: System Firmware could not establish routing from the local crossbar that would be needed to complete the route around routing. Recommended Action: Collect IPMI Event Logs and contact your HP Support Representative to investigate the fabric subsystem. WBEM EventID: 5191. WBEM ProviderName: FPL_IndicationProvider. An invalid or non-supported TPM (Trusted Platform Module) has been detected. Ensure that the TPM is fully seated into the system board and verify the operating system is TPM capable. Probable Cause: An invalid, non supported TPM is being used in the system. Recommended Action: Contact HP for support. WBEM EventID: 5193. WBEM ProviderName: FPL_IndicationProvider. Invalid or unsupported TPM detected in the system. TPM is disabled. Probable Cause: An invalid or unsupported TPM has been detected in the system. TPM is disabled. Recommended Action: Contact HP support. WBEM EventID: 5194. WBEM ProviderName: FPL_IndicationProvider. 82 WBEM Provider Event Tables