HP Integrity rx2800 HP Insight Management WBEM Provider Events Reference Guide - Page 67
Error writing the XBC ROUTE_TABLE_ENABLE_MASK CSR. Data field: route set
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
10429 Warning 10431 Warning 10432 Warning 10435 Warning 10436 Warning 10439 Warning 10475 Warning 10481 Warning 10482 Warning 10483 Warning 10487 Warning ArfPhase4 was unable to set up the Non-Coherent link select to at least one cell in its alive/gsm sharing set. Data field: bitmap of unreachable cells. Probable Cause: System firmware was unable to find valid routes to each cell in a previously good partition. Possible cable/connection problems. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2955. WBEM ProviderName: FPL_IndicationProvider. Unable to set the Non-Coherent route. Data field: (sourceCell 32) | (cell set passed in to SetupNCTable). Probable Cause: System firmware was unable to write various fabric hardware registers. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2956. WBEM ProviderName: FPL_IndicationProvider. Unable to setup the Coherent route table for a cell in our partition. Data field: (sourceCell 32) | (cell set passed in to SetupCohTable). Probable Cause: System firmware was unable to write various fabric hardware registers. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2957. WBEM ProviderName: FPL_IndicationProvider. Error writing the XBC ROUTE_TABLE_ENABLE_MASK CSR. Data field: (route set to disable) | (xbcNum 32) | (xbc port 48). Probable Cause: System firmware was unable to write various fabric hardware registers. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2958. WBEM ProviderName: FPL_IndicationProvider. The Arches Fabric vertex module returned an unexpected error during Non-Coherent table setup. Data field: (return value) | (sourceCell 32) | (dest cell 48). Probable Cause: Internal firmware error or data corruption. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2959. WBEM ProviderName: FPL_IndicationProvider. A write to a Skyline Global LINK_SEL_COHx CSR failed. Data field: cell number of the Skyline that failed. Probable Cause: System firmware was unable to write a fabric hardware register. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2960. WBEM ProviderName: FPL_IndicationProvider. Unable to write the XBC port scratch CSR with the routing state. Data field: (routing state) | (xbcNum 32) | (portNum 48). Probable Cause: System firmware was unable to write a fabric hardware register. Recommended Action: Capture IPMI event logs, look for additional errors. Contact your HP Support Representative to analyze the fabric. WBEM EventID: 2962. WBEM ProviderName: FPL_IndicationProvider. System Firmware was unable to access the configured set stored in the complex profile. Probable Cause: SFW was unable to access the configured set stored in the complex profile. Recommended Action: Collect IPMI events and contact your HP Support Representative. WBEM EventID: 6874. WBEM ProviderName: FPL_IndicationProvider. System Firmware detected an error during Fabric Init. Probable Cause: Error detected by SFW during Fabric Init. Recommended Action: Collect IMPI events and contact your HP Support Representative for assistance. WBEM EventID: 6869. WBEM ProviderName: FPL_IndicationProvider. System Firmware detected a failure during Fabric Init. Probable Cause: Failure detected by SFW during Fabric Init. Recommended Action: Collect IPMI events and contact your HP Support Representative for assistance. WBEM EventID: 6870. WBEM ProviderName: FPL_IndicationProvider. System Firmware detected an error during Fabric Optimize. Probable Cause: Error detected by SFW during Fabric Optimize. Recommended Action: Collect IMPI events and contact your HP Support Representative for assistance. WBEM EventID: 6871. WBEM ProviderName: FPL_IndicationProvider. Platform Events 67