HP LH4r HP Netserver LXr 8500 Installation Guide - Page 100
Preparing the Rack
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Chapter 8 Rack Mounting the HP NetServer HP NetServer Rack Mount Parts List Ensure the rack-mounting kit provided with the HP NetServer contains the following parts: Table 8-1. Parts for Rack Mount Kit Quantity 2 12 12 8 1 Description Slides Rack Nuts Rack Nut Screws (M5 x 16mm) Screws for Slides (8-32 x ¼ inch) Template Preparing the Rack The rack nuts and slide mechanism must be connected to the rack before installing the HP NetServer LXr 8500 into the rack. A cardboard rack-mounting template comes with the HP NetServer. This template shows you where to mount the nuts on the rack. Attaching Rack Nuts to the Rack Use this section to attach the rack nuts to the front and rear columns of the HP System/E or HP System/U rack. The rack nuts are used to hold the HP NetServer's slides in place and to secure the front of the HP NetServer to the rack. CAUTION If other rack components are to be mounted in the rack below the HP NetServer, install those components before starting to mount the HP NetServer. NOTE Use the HP Rack Configuration Tools to determine where in the rack to mount the HP NetServer. The tools are available at: http: //www.hp.com/netserver/servsup 1. Find the rack-mounting template. 92