HP LH4r HP Netserver LXr 8500 Installation Guide - Page 115
Connecting the Monitor, Keyboard, Mouse, and UPS
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
9 Connecting the Monitor, Keyboard, Mouse, and UPS Introduction This chapter provides the instructions for connecting a monitor, keyboard, mouse and Uninterruptible Power Supply (UPS) to the rear of the HP NetServer LXr 8500. The I/O Riser board on the I/O baseboard, inside the HP NetServer, provides the circuitry and a connector for the video, mouse, serial (2), parallel, and keyboard ports at the rear of the chassis. See Figure 9-1. Connecting the Monitor, Keyboard, Mouse, and UPS To connect the peripheral control devices and the UPS to the HP NetServer refer to the following procedure: 1. Connect the monitor, keyboard and mouse to the HP NetServer using the connections provided on the rear of the chassis. See Figure 9-1. Keyboard Mouse Serial Port B Serial Port A VGA LPT1 USB Not Used Figure 9-1. Connection Ports (rear of chassis) 107