HP LH4r HP Netserver LXr 8500 Installation Guide - Page 44
Remove the, PCI Access Panel
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Chapter 3 Remove the PCI Access Panel Opening and Closing the HP NetServer Figure 3-7. Lifting Off the Access Panel 5. To replace the PCI access panel, lower it onto the top cover, about ½ inch to the rear of its normally closed position. See Figure 3-6. 6. Push the PCI access panel forward until the tabs along its front edge line up with the screw holes on the top cover. 7. Re-attach the two T-15 Torx® screws to the top cover. Be sure you use the short T-15 Torx® screws. 36
Chapter 3
Opening and Closing the HP NetServer
36
Remove the
PCI Access Panel
Figure 3-7.
Lifting Off the Access Panel
5.
To replace the PCI access panel, lower it onto the top cover, about ½ inch
to the rear of its normally closed position.
See Figure 3-6.
6.
Push the PCI access panel forward until the tabs along its front edge line
up with the screw holes on the top cover.
7.
Re-attach the two T-15 Torx
®
screws to the top cover.
Be sure you use the short T-15 Torx
®
screws.