HP LH4r HP Netserver LXr 8500 Installation Guide - Page 78
Close the latch on the PCI board guide. See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Chapter 6 Ensure PCI hold-down latch is at least half open before inserting board. Installing Additional Boards Insert board Figure 6-6. Installing the Accessory Board 13. Close the PCI hold-down latch by pushing it in from the rear of the HP NetServer until it clicks. See Figure 6-7. The PCI hold-down latch should click when you push it into place. 14. Close the latch on the PCI board guide. See Figure 6-7. 15. If the installed accessory board requires an external connection or a connection to the I/O baseboard, ensure the cable is properly attached. Refer to the accessory board documentation for connection requirements. 70
Chapter 6
Installing Additional Boards
70
Ensure
PCI hold-down
latch is at least half open
before inserting board.
Insert board
Figure 6-6. Installing the Accessory Board
13.
Close the PCI hold-down latch by pushing it in from the rear of the HP
NetServer until it clicks. See Figure 6-7.
The PCI hold-down latch should click when you push it into place.
14.
Close the latch on the PCI board guide. See Figure 6-7.
15.
If the installed accessory board requires an external connection or a
connection to the I/O baseboard, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.