HP LH4r HP Netserver LXr 8500 Installation Guide - Page 166
Slide Member, Leveler, Screws 4
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
Chapter 13 Alternative Rack Mounting Placing the HP NetServer in the Rack Use this procedure to position the HP NetServer into the extended slides and secure the chassis to the slides. 1. Ensure you have extended the anti-tip foot from the rack, before continuing this procedure. 2. Pull out both slides until the slide members are fully extended. The slides click into position when locked. This locked position prevents the slides from moving back into the rack, unless the release latches are pressed as shown in Figure 13-7. WARNING If you have not already done so, pull the rack's anti-tip foot forward out of the bottom of the rack to prevent rack instability while mounting the HP NetServer. Failure to do so could result in injury and equipment damage. Figure 13-5 shows the anti-tip foot in position. Slide Member Leveler Screws (4) Slide Member Figure 13-7. Pulling Out the Slides 158