HP LH4r HP Netserver LXr 8500 Installation Guide - Page 162
Brackets, Slide
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Chapter 13 Alternative Rack Mounting Slide Brackets Figure 13-3. Removing the Slides' Mounting Flanges 2. Pull the anti-tip foot forward out of the bottom of the rack. 3. Hold the template alongside the inside face (side) of the left-front rack column. 4. Line up the template with the bottom line of the rack space the HP NetServer will occupy. The template covers a span of 7 EIA units, which is the height requirement of the HP NetServer. 5. Mark the single hole indicated by the template for future reference. The template directs you to a single hole in the rack column used for mounting the slide. 6. If you don't have the template, use the markings shown in Figure 13-4 to determine which hole on the column the slide mounts through. 154
Chapter 13
Alternative Rack Mounting
154
Brackets
Slide
Figure 13-3.
Removing the Slides’ Mounting Flanges
2.
Pull the anti-tip foot forward out of the bottom of the rack.
3.
Hold the template alongside the inside face (side) of the left-front rack
column.
4.
Line up the template with the bottom line of the rack space the HP
NetServer will occupy.
The template covers a span of 7 EIA units, which is the height requirement
of the HP NetServer.
5.
Mark the single hole indicated by the template for future reference.
The template directs you to a single hole in the rack column used for
mounting the slide.
6.
If you don’t have the template, use the markings shown in Figure 13-4 to
determine which hole on the column the slide mounts through.