HP LH4r HP Netserver LXr 8500 Installation Guide - Page 76
Cover, A. Push here, from outside, to move in., B. Lift Up, and Out, of Slot
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Chapter 6 Installing Additional Boards A. Push here from outside to move in. PCI Slot Cover B. Lift Up and Out of Slot Figure 6-4. Removing the PCI Slot Cover NOTE To prevent intermittent problems, ensure each unused PCI slot has a PCI slot cover in place. If a PCI board is removed and not re-installed, you must ensure the unused slot has a PCI slot cover installed. 9. Open the PCI board guide latch before installing the new PCI board. See Figure 6-5. CAUTION Do not bend the PCI board to install it into the slot. If the PCI board is full-length, the PCI board guide latch at the rear of the PCI slot is used to hold the board in place. The latch at the top of PCI board guide prevents the board from moving during HP NetServer transportation and handling when performing PCI Hot Plug operations. 68