HP LH4r HP Netserver LXr 8500 Installation Guide - Page 53
Filler, Panel, Peripheral, Bay Assembly, Front of, NetServer, Memory, Cover, Thumb, Screws 3, Handle
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Chapter 4 Installing Mass Storage Devices Front of NetServer LCD Panel Handle Peripheral Bay Assembly Thumb Screws (3) Filler Panel Handle Memory Bay Cover Figure 4-4. Removing the Peripheral Bay 10. Remove the two screws (Torx® T-15) holding the cover to the peripheral bay and remove the cover. See Figure 4-5. 11. Remove the filler panel from the tape drive slot in the peripheral bay. See Figure 4-5. 12. Remove the two mounting rails connected to the filler panel and save the rails and screws. See Figure 4-5. This may require a T-10 Torx® driver instead of a T-15 driver. 13. Remove the tape drive from the shipping container and its protective bag. 14. Remove the mounting bracket/hardware installed on the tape drive. This may require a T-10 Torx® driver instead of a T-15 driver. 45