HP LH4r HP Netserver LXr 8500 Installation Guide - Page 62
Place the memory board, component-side up, on a firm anti-static surface
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Chapter 5 Installing Additional Memory Retaining Latches A. Pull open retaining latches on memory board. DIMM installed on underside of board. B. Pull board from its slot. Figure 5-4. Removing a Memory Board 10. Hold the memory board by the corners and carefully pull the board from its slot. See Figure 5-4. NOTE If you need to remove both memory boards, repeat Steps 2 and 3 for the other board. 11. Place the memory board, component-side up, on a firm anti-static surface for protection. NOTE The component-side of the memory board must be face-up and rest on a firm surface to apply pressure to the DIMM. 54
Chapter 5
Installing Additional Memory
54
A. Pull open retaining
latches on memory
board.
B. Pull board from
its slot.
Retaining
Latches
DIMM installed
on underside
of board.
Figure 5-4. Removing a Memory Board
10.
Hold the memory board by the corners and carefully pull the board from its
slot. See Figure 5-4.
NOTE
If you need to remove both memory boards, repeat Steps 2 and
3 for the other board.
11.
Place the memory board, component-side up, on a firm anti-static surface
for protection.
NOTE
The component-side of the memory board must be face-up and
rest on a firm surface to apply pressure to the DIMM.