Kyocera TASKalfa Pro 15000c Pro 15000c Basic Operation Guide - Page 142

Basic Operation > Loading Originals IMPORTANT • Do not push the document processor forcefully when you close it. Excessive pressure may crack the platen glass. • When placing books or magazines on the machine, do so with the document processor in the open position. Loading Originals in the Document Processor The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are scanned. The document processor supports the following types of originals. Detail Weight Sizes No. of sheets Document Processor 1-side: 35 to 220 g/m2 Duplex: 50 to 220 g/m2 Maximum A3/Ledger (11.69" × 17"/ 297 × 432 mm) (Long-sized 11.69" × 86.62"/ 297 × 2,200 mm) to Minimum A6-R/Statement-R (4.13" × 5.82"/105 × 148 mm) 270 sheets (50 to 80 g/m2) maximum Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the document processor may become dirty. • Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam.) • Originals with adhesive tape or glue • Originals with cut-out sections • Curled original • Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.) • Carbon paper • Crumpled paper IMPORTANT • Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. • Do not make an impact on the document processor top cover, such as aligning the originals on the top cover. It may cause an error in the document processor. • Do not load the printouts from this machine on the document processor as original. Ink may adhere to the feed roller in the document processor, which may cause streaks in the scanned image. 1 Adjust the original width guides. 4-21