Kyocera TASKalfa Pro 15000c Pro 15000c Basic Operation Guide - Page 583

Troubleshooting > Troubleshooting When Feeding Paper 2 The maximum value among 4 corners is the curl amount of the paper. Tolerable value of the curl amount is as follows. Paper weight Tolerable value of the curl amount 52.3 to 299.9 g/m2 5 mm or less 300 to 360 g/m2 3 mm or less In case the curl amount exceeds the tolerable value at the above measurement, correct the curl in the next step 3-3. In case the curl amount is within the tolerable value, go to step 4, 3 Place the paper bundle on the flat surface with the curl side face-down. 4 Hold the leading edge of the paper bundle in the paper feed direction and correct the curl by rolling up the paper in the reverse direction of the curl. Paper direction 5 Hold the trailing edge of the paper bundle and correct the curl as done at above step 3-4. 6 Turn over the upward curl paper and reload it in the paper tray. Loading in the Paper Feeder (Cassette 5 to 8) (page 7-33) 7 In case that no improvement is observed, then go to next step. 4 Change paper feeding setting 1 [System Menu/Counter] key > [Device Settings] > [Paper Feeding] > [Cassette 1 (to 8) Settings] > [Manual] > [Paper Feeder Action] NOTE You can select [Paper Settings] from taskbar, and then access to [Cassette 5 (to 8) Settings] > [Manual] > [Paper Feeder Action]. 2 Select [Facilitate Feed]. Check the operation and if the phenomenon is not solved, change to [Facilitate Feed (Maximum)]. NOTE If you change the paper type after setting, change the setting suitable for that paper. 19-30