Kyocera TASKalfa Pro 15000c Pro 15000c Basic Operation Guide - Page 168

Using Custom Paper > Operation Flow Operation Flow The steps required to print from the machine using custom paper are as follows. 1 Load custom paper in the paper source. IMPORTANT When printing on paper of a size different from the spoilage, load the paper in other than cassette 1 and specify the paper source from the system menu. Checking the Counter (page 4-13) Cassette 1 (to 8) Settings (page 15-13) 2 Set the paper size, type, and weight. Setting the Paper (page 6-3) NOTE The paper can also be set for each paper source from Command Center RX. Setting from Command Center RX (page 6-17) 3 Perform a trial print and check the result. • If a paper jam occurs, adjust the main unit paper feeding speed or ink discharge distance. Preventing Paper Jams (Cassette 1 to 4) (page 6-4) Preventing Image Rubbing (page 6-7) • If double-feeding or non-feeding occurs, adjust the flow of the paper feeder fan. Preventing Paper Jams (Cassette 5 to 8) (page 6-4) • If the printouts are not output properly due to paper curl, adjust the degree of the curl. Reducing Paper Curl When Outputting to the Right Tray (page 6-5) Reducing Paper Curling When Outputting to the 5,000-sheet Stacker or Finisher (page 6-6) • If skewed folding of the leading edge of the paper occurs, or creases appear, use the test chart to correct the skew. Correcting Paper Skew (page 6-8) • If the print start positions on the front side and back side are out of place, use the chart to correct the print start positions. Adjusting the Print Position to Correct Image Drift (page 6-10) • If there is color drift on only the leading edge or trailing edge of the paper, use the test chart to adjust the color drift. Adjusting Color Drift (page 6-15) 6-2