Kyocera TASKalfa Pro 15000c Pro 15000c Basic Operation Guide - Page 603
Other Trouble, Printing does not start
View all Kyocera TASKalfa Pro 15000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 603 highlights
Troubleshooting > Other Trouble Other Trouble Printing does not start When the following machine operation troubles occur, implement appropriate procedures. Symptom Checkpoints Corrective Actions Reference Page An extended function does not start. Is the Auto Panel Reset time short? Set the Auto Panel Reset time to 30 page 15-7 seconds or more. The screen does not respond when the power switch is turned on. Is the machine plugged in? Is the machine powered on? Plug the power cord into an AC outlet. Turn on the main power switch. ― page 3-5 Cannot print by sending a Is there a message on the screen? job from the printer driver. Determine the appropriate response page 19-60 to the message and respond accordingly. Is the machine in Sleep mode? Select any key on the operation panel to recover the machine from Sleep mode. page 3-9 Blank sheets are ejected. ― Check that the settings of the ― application software. Are the originals loaded correctly? When placing originals on the platen, place them face-down and align them with the original size indicator plates. page 4-20 When placing originals in the document processor, place them face-up. page 4-21 Cannot print. Is the machine plugged in? Plug the power cord into an AC ― outlet. Is the machine powered on? Turn on the main power switch. page 3-5 Are the USB cable and network cable connected? Connect the correct USB cable and page 3-4 network cable securely. When the network is configured The number of host name and ― using the name resolution, does the domain name which can be used IP address (private address) of the with the machine is one other network which can not access respectively. Configure the network coexists? under this restriction. Change the settings of name resolution such as NetBEUI and DNS, or network environment settings. Command Center RX User Guide Cannot print with USB memory. USB memory not recognized. Is the USB host blocked? ― Select [Unblock] in the USB host settings. Check that the USB memory is securely plugged into the machine. page 15-58 ― 19-50