Lantronix X300 Series X300 Series User Guide Rev B - Page 135
PPPoE, PAP/CHAP password
View all Lantronix X300 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
11: Network Parameters Interface Firewall Settings Create/Assign firewall -zone Description Select the interface to be configured. Select more than one interface, if parameter creating a bridge over multiple interfaces is enabled. Select the firewall zone to be assigned to the interface. Select unspecified - or - create to remove the interface or assign a new zone to the interface respectively. Enter the name of the new zone in the text box and click Save & Apply button. PPPoE Table 11-7 describes the PPPoE protocol settings. Table 11-7 PPPoE Protocol Settings Parameters General Settings Protocol Description PPPoE - Point to Point Protocol over Ethernet Bring up on boot Allows the interface to be live after every reboot. Bring up on boot is checked by default. PAP/CHAP username Enter the PAP/CHAP username. The default password is admin. PAP/CHAP password Access Concentrator Service Name Enter the PAP/CHAP password. Enter the access concentrator name. Enter the service name. Note: Access Concentrator name and Service Name gets auto populated from the PPPoE Access Point router if they are not explicitly provided Advanced Settings Use builtin IPv6 management Force link Allows to use the built in IPv6 management configuration Select this option to assign interface properties regardless of the link being active or not. If not selected, items are assigned only after the link has become active. This is the default. Obtain IPv6-Address Use default gateway Allow IPv6 negotiation on the PPP link Select to use the default gateway. If unselected, no default route will be configured. Use DNS servers advertised by peer Use gateway metric Select to use DNS servers advertised by peer, otherwise ignore advertised DNS servers. Enter gateway metric. LCP echo failure threshold Enter the number of LCP echo request failures allowed before considering the peer dead. Set to zero (0) to ignore failures. X300 Series IoT Cellular Gateway User Guide 135