Lantronix X300 Series X300 Series User Guide Rev B - Page 69

8: System Parameters Start priority Initscript Enable/Disable Start Restart Stop Table 8-8 Initscripts Actions Description Displays the priority of when the initscript is run during startup. Order of priority is from 00 to 99. Displays the name of the initscript Displays the current state as Enabled or Disabled. Click the button to disable or enable the initscript. Starts the initscript immediately Restarts the initscript immediately Stops the initscript immediately Local Startup System > Startup > Local Startup The local startup file (/etc/rc.local) contains custom commands that are run at the end of the boot process, after the system is initialized. By default, it is empty. To configure the local startup file: 1. Go to System > Startup > Local Startup. 2. In the editor, type custom commands on any line before the line "exit 0". Make sure that the file ends with the line "exit 0". 3. Click Save. Changes will take effect on the next reboot. Scheduled Tasks System > Scheduled Tasks This feature lets you schedule cron jobs to run at a fixed time, date, or interval. Enter each task on a separate line in the crontab file. Tasks are specified using the following syntax: * * * * * command to execute day of the week (0-6) (Sunday=0 month (1-12 day of month (1-31 hour (0-23 min (0-59) To configure scheduled tasks: 1. Go to System > Scheduled Tasks. Note: If the editor is empty, you must restart the cron service before creating a scheduled task. To restart the cron service, go to Services > Service Actions in the web interface. 2. Enter the cron task according to the syntax described above. Table 8-9 lists available shortcuts. X300 Series IoT Cellular Gateway User Guide 69