Lantronix X300 Series X300 Series User Guide Rev B - Page 137

11: Network Parameters Description Modem init timeout Enter the maximum wait time in seconds for the modem to become ready. The default modem initiation timeout 20 seconds. Use default gateway Click to configure a default gateway route. If unchecked, no default route is configured. Use gateway metric Enter the gateway metric. Default is 5 Use DNS servers advertised by Click to enable, otherwise leave box unchecked to ignore the peer advertised DNS servers. LCP echo failure threshold Enter the number of LCP echo failures after which the peer is presumed to be dead. Enter 0 to ignore failures. LCP echo interval Send LCP echo requests at the given interval in seconds. Failure threshold must be configured for this to be effective. Inactivity timeout Number of seconds for inactivity timeout. Enter 0 to persist the connection. Firewall Settings Create/Assign firewall -zone Select the firewall zone to be assigned to the interface. Select unspecified - or - custom to remove the interface or assign a new zone to the interface respectively. Enter the name of the new zone in the text box. Embedded SIM / External SIM Settings PDP Type IP stack mode  IPv4  IPv6  IPv4/IPv6 Service Type  Automatic  Cat M1  GSM APN Enter the Access Point Name provided by the cellular network operator. PIN Enter the PIN code to unlock the SIM card PUK Enter the PUK (personal unblocking key) used to unblock the SIM card if the PIN code has been repeatedly entered incorrectly Authentication Type Enter the authentication method used for the cellular connection.  PAP/CHAP  PAP (requires username and password)  CHAP (requires username and password)  None Enable roaming Enable data roaming on the cellular interface Cid Enter Cid value. It is usually okay to leave as the default value. X300 Series IoT Cellular Gateway User Guide 137