TRENDnet TEW-829DRU Users Guide - Page 59

TRENDnet User's Guide One-to-One NAT Network > Firewall > One-to-One NAT If you have multiple static public WAN/Internet IP addresses assigned by your ISP, you can map the additional public IP addresses to a local computer or device on your network and allow all or specific ports or services similar to port forwarding but using different public IP addresses through your router. Please check with your ISP if you have multiple static public IP addresses available that can be used to map to devices on your local network. Note: This feature will only work when using a static IP address WAN type/protocol. 1. Log into your router management page (see "Access your router management page" on page 8). 2. Click on Network, click on Firewall, and click on the One-to-One NAT tab. 3. Review the settings below. When complete, click Add to add the new entry to the list and Apply to save and commit your changes.  Name - Enter a name for the new one-to-one NAT rule.  Private IP address - Click the drop-down list to select a device from the list or enter the local/internal IP address of the device to forward the port/protocol service.  Public - Enter the additional static public Internet IP address you would like to map to the local/internal IP address. © Copyright 2019 TRENDnet. All Rights Reserved. Limited Warranty  External Interface - Click the drop-down list to select the external WAN interface(s) to allow: WAN1, WAN2, or WAN1+WAN2. For example, choosing WAN1 will only allow the port forward to work on inbound connection requests on WAN1 only and inbound connections requests on WAN2 will be denied.  Forwarding Mode - Select DMZ to forward all ports/protocols or Port Forwarding to specify which ports/protocols to allow. o DMZ - Selecting this option will set the rule to forward all ports/protocols to the device internal private IP address.  Schedule - Allows you to select a schedule when the port forwarding rule should be enabled or disabled. o Port Forward - Selecting this option will allow to set the specific ports/protocols to allow for the rule.  Protocol - Click the drop-down list to select the protocol for the service to allow: TCP, UDP, TCP+UDP, ICMP, or Custom.  External Port - Enter the external port number for the service to allow. Note: You can also enter a consecutive range of ports in the following format: 80-90  Internal Port - Enter the internal port number for the service to allow. Note: You can also enter a consecutive range of ports in the following format: 80-90 Typically, the internal port or port range is same as the external port or port range. 52