Cisco 7925G Administration Guide - Page 134

Best Practices Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server Best Practices This section describes the best practices recommended for setting up and using the Cisco Unified Wireless IP Phone 7925G CU on the Wavelink Avalanche server. • Ensure that the phone is registered to Cisco Unified Communications Manager. • Try out this process with one or two phones before deploying to many phones. • Set up a VLAN that only has access to the Wavelink server. • Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this option, see Assigning the Wavelink Server from the Phone, page 6-2. • Configure a Cisco Access Point to use a default SSID of "cisco" with open authentication and no encryption. Assigning the Wavelink Server If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually assign it. Note Do not perform this task if you previously configured the Wavelink server address using DHCP Option 149. To assign the Wavelink server on the phone, choose one of the following methods: • Assigning the Wavelink Server from the Phone, page 6-2 • Assigning the Wavelink Server using the Phone Web Page, page 6-3 Assigning the Wavelink Server from the Phone To assign the Wavelink server from the phone, follow these steps: Procedure Step 1 Step 2 Step 3 Step 4 Step 5 Turn on the phone and verify that it is installed with the required firmware version and is registered to Cisco Unified Communications Manager. Choose SETTINGS > System Configuration > Wavelink. Unlock the phone by pressing **#. In the Alternate Wavelink Server option, choose Yes. Enter the IP address of the Wavelink server, and press Save. Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1) 6-2 OL-15984-01