Cisco 7925G Administration Guide - Page 197

10 C H A P T E R Troubleshooting the Cisco Unified Wireless IP Phone 7925G This chapter provides information that can assist you in troubleshooting your Cisco Unified Wireless IP Phone. It contains the following sections: • Resolving Startup and Connectivity Problems, page 10-1 • Resolving Voice Quality and Roaming, page 10-8 • General Troubleshooting Information, page 10-14 • Erasing the Local Configuration, page 10-18 For additional troubleshooting information, you can refer to the Cisco Unified Communications Manager Troubleshooting Guide. Resolving Startup and Connectivity Problems After installing a Cisco Unified IP Phone 7960 in your network and adding it to Cisco Unified Communications Manager Administration, the phone should start up as described in the "Understanding the Phone Startup Process" section on page 3-17. If the phone does not start up properly, see the following sections for troubleshooting information: • Symptom: Incomplete Startup Process, page 10-1 • Symptom: No Association to Cisco Aironet Access Points, page 10-2 • Symptom: No Registration to Cisco Unified Communications Manager, page 10-3 Symptom: Incomplete Startup Process When an IP Phone connects to the wireless network, the phone should go through its normal startup process and the phone screen should display information. If the phone does not complete the startup process, the cause might be due to low RF signal strength, network outages, a dead battery in the phone, or the phone might not be functional. To determine whether the phone is functional, follow these suggestions to systematically eliminate these potential problems: 1. Verify that the wired network is accessible by placing calls to and from other wired Cisco Unified IP Phones. 2. Verify that the wireless network is accessible: OL-15984-01 Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1) 10-1