Cisco 7925G Administration Guide - Page 158

Specific Configuration Options for the Cisco Unified Wireless IP Phone 7925G Chapter 7 Configuring Features, Templates, Services, and Users • Settings Access-Enables, disables, or restricts access to local configuration settings in the Settings menus. With restricted access, only the Phone Settings menu is accessible. With disabled access, no options appear when you access the Settings menu on the phone. Options are Enabled, Disabled, and Restricted. • Web Access-Determines the level of access to the web pages for the phone. Provides Disabled, Read only, and Full access to a phone's web pages through a web browser. Options are Read Only, Full, Disabled. • Profile 1-4-Locks or unlocks the network profiles. If locked, the phone user cannot modify the network profile. Options are Unlocked and Locked. • Load Server-Identifies the alternate server that the phone will use to obtain firmware loads and upgrades. Enter an IP address or host name for the server. • Admin Password (Cisco Unified Communications Manager 5.0 and later)-Password to access the configuration web pages for the phone. Default password is "CiscoCisco." Password must be 8-32 characters. Caution When setting the Administration Password in the Product Specific Configuration section in Cisco Unified Communications Manager Administration 5.0 or later, you must enable TFTP encryption. Otherwise, the password appears in readable text in the phone configuration file and can be viewed from any host that has access to TFTP server. • Special Numbers-Identifies special phone numbers that do not require unlocking the keypad to call, such as 911 or an emergency number. Enter numbers up to 16 digits in length. • Application URL-Specifies the URL that the phone contacts application services. The maximum length is 256 characters. • "Send" Key Action-Enables onhook dialing which displays a list of the last numbers dialed on the phone; offhook dialing which sends an SCCP offhook message to the Cisco Unified Communications Manager server. • Days Display Not Active-Specifies the days that the backlight is off by default. The list contains all the days of the week. To turn off the backlight on the specified days, use the Control key plus the days. • Display On Time-Indicates the time of day the display turns on automatically. • Display On Duration-Indicates the amount of time the display is active. No value indicates the end of a day. Maximum value is 24 hours. Input the number of hours and minutes, for example 1:30 would indicate a display time of 1 hour and 30 minutes. • Display Idle Timeout-Specifies when the display times out after a configurable amount of inactivity. It continually resets if the phone is active. The default is to time out after 1 hour. Maximum value is 24 hours. Input the number of hours and minutes, for example 1:30 would indicate a display time of 1 hour and 30 minutes. • Phone Book Web Access-Controls the access of the local phone book so that it can be accessed by using the web page for the phone. It works with the Web Access parameter. When Web Access is disabled, the local phone book is not accessible. • Unlock-Settings Sequence (**#)-Specifies the unlock settings as **#. The phone cannot be unlocked using any other sequence if this parameter is enabled. The user does not have write-access to the phone Settings menu if this parameter is enabled unless the sequence is entered on the phone. • Application Button Activation Timer-Specifies the amount of time to hold down the Application Button to active the application. The values are seconds. 7-14 Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1) OL-15984-01