D-Link DWS-4026 Product Manual - Page 280

D-Link Unified Access System Software User Manual 12/10/09 reconfigured, disconnected, or powered off). This leads to stale information in the ARP cache unless entries are updated in reaction to new information seen on the network, periodically refreshed to determine if an address still exists, or removed from the cache if the entry has not been identified as a sender of an ARP packet during the course of an ageout interval, usually specified via configuration. The LAN > L3 Features > ARP folder contains links to the following web pages that configure and display ARP detail: • "ARP Create" • "ARP Table Configuration" ARP CREATE Use the ARP Create page to add an entry to the Address Resolution Protocol table. To display the page, click LAN > L3 Features > ARP > ARP Create in the navigation tree. Figure 192: ARP Create Field IP Address MAC Address Table 173: ARP Create Fields Description Enter the IP address you want to add. It must be the IP address of a device on a subnet attached to one of the switch's existing routing interfaces. The unicast MAC address of the device. Enter the address as six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40. • After you enter an IP address and the associated MAC address, click Submit to apply the changes to the system and create the entry in the ARP table. Page 280 Configuring ARP Document 34CSFP6XXUWS-SWUM100-D7