D-Link DWS-4026 Product Manual - Page 449
Debugging the AP, Table 273, Advanced AP Management, Field, Description
UPC - 790069325533
View all D-Link DWS-4026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 449 highlights
Software User Manual 12/10/09 D-Link Unified Access System you can also manually change the RF channel and power for each radio on an AP. The manual power and channel changes override the settings configured in the AP profile (including automatic channel selection) and take effect immediately. The manual channel and power assignments are not retained when the AP is reset or if the profile is reapplied to the AP, such as when the AP disassociates and reassociates with the switch. Figure 309: Advanced AP Management Each AP managed by the Unified Switch is listed by its MAC address and location. The location is based on the value in the RADIUS or local Valid AP database. Table 273 describes the Advanced features you can configure for the AP. Field MAC Address Location Debug Radio Channel Power Table 273: Advanced AP Management Description Shows the MAC address of the AP. Shows the AP location, which is based on the value configured in the RADIUS or local Valid AP database. To help you troubleshoot, you can enable Telnet access to the AP so that you can debug the device from the CLI. The Debug field shows the debug status and can be one of the following: • Disabled • Set Requested • Set in Progress • Enabled To change the status, click the Debug status link. The Managed AP Debug page appears. Table 274 describes the fields on the new page. Identifies the radio to which the channel and power settings apply. Click the Channel link to access the Managed AP Channel/Power Adjust page. From that page, you can set a new channel for Radio 1 or Radio 2. The available channels depend on the radio mode and country in which the APs operate. The manual channel change overrides the channel configured in the AP profile and is not retained when the AP reboots or when the AP profile is reapplied.Table 275 on page 451 describes the fields on the new page. Click the Power link to access the Managed AP Channel/Power Adjust page. From that page, you can set a new power level for the AP. The manual power change overrides the power setting configured in the AP profile and is not retained when the AP reboots or when the AP profile is reapplied. Table 275 on page 451 describes the fields on the new page. Debugging the AP You can enable debugging on an AP to allow Telnet access to the access point. Once you Telnet to the AP, you can issue commands from the CLI to help you troubleshoot. Document 34CSFP6XXUWS-SWUM100-D7 AP Management Page 449