D-Link DWS-4026 Product Manual - Page 283
Configuring Global and Interface IP Settings, IP Configuration, Table 176, IP Configuration Fields
UPC - 790069325533
View all D-Link DWS-4026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
Software User Manual 12/10/09 D-Link Unified Access System CONFIGURING GLOBAL AND INTERFACE IP SETTINGS The LAN > L3 Features > IP folder contains links to the following web pages that configure IP routing data: • "IP Configuration" • "IP Interface Configuration" IP CONFIGURATION Use the IP Configuration page to configure routing parameters for the switch as opposed to an interface. To display the page, click LAN > L3 Features > IP > Configuration in the navigation tree. Field Default Time to Live Routing Mode ICMP Echo Replies ICMP Redirects ICMP Rate Limit Interval Figure 194: IP Configuration Table 176: IP Configuration Fields Description The default value inserted into the Time-To-Live field of the IP header of datagrams originated by the switch, if a TTL value is not supplied by the transport layer protocol. Select Enable or Disable from the dropdown menu. You must enable routing for the switch before you can route through any of the interfaces. Routing is also enabled or disabled per VLAN interface. The default value is Disable. Select Enable or Disable from the dropdown menu. If you select Enable, then only the router can send ECHO replies. By default, ICMP Echo Replies are sent for echo requests. If this is enabled globally and on the interface level, then only the router can send ICMP redirects. To control the ICMP error packets, you can specify the number of ICMP error packets that are allowed per burst interval. By default, the rate limit is 100 packets per second, i.e. the burst interval is 1000 milliseconds. To disable ICMP rate limiting, set this field to zero. The valid rate interval range is 0 to 2147483647 milliseconds. Document 34CSFP6XXUWS-SWUM100-D7 Configuring Global and Interface IP Settings Page 283