D-Link DWS-4026 Product Manual - Page 504

D-Link Unified Access System Software User Manual 12/10/09 If you use the local database for AP Validation, you can click the WLAN > Administration > Basic Setup > Valid AP tab to modify the AP configuration. If you use a RADIUS server for AP validation, you must add the MAC address of the AP to the RADIUS server database. Click the MAC address of the AP to view more information about the AP. If the AP is not a D-Link AP, some values are unknown. Field MAC Address IP Address Last Failure Type Age Table 326: Access Point Authentication Failure Status Description The Ethernet address of the AP. If the MAC address of the AP is followed by an asterisk (*), it was reported by a peer switch. The IP address of the AP. Indicates the last type of failure that occurred, which can be one of the following: • Local Authentication • No Database Entry • Not Managed • RADIUS Authentication • RADIUS Challenged • RADIUS Unreachable • Invalid RADIUS Response • Invalid Profile ID • Profile Mismatch-Hardware Type Time since failure occurred. To view additional data (beacon information) for an AP in the authentication failure list, you can search for the MAC address of the failed AP on the Rogue/RF Scan page. However, some APs that attempt to contact the switch on the wired network might not be detected during the RF scan. Figure 350: AP Authentication Failure Details Table 327 describes the fields on the detailed Access Point Authentication Failure Status page. Page 504 Monitoring and Managing Intrusion Detection Document 34CSFP6XXUWS-SWUM100-D7