D-Link DWS-4026 Product Manual - Page 436

D-Link Unified Access System Software User Manual 12/10/09 VALID ACCESS POINT SUMMARY The Wireless Global Configuration page contains a field to select whether to use a local or RADIUS database for AP Validation. The Valid Access Point Summary page contains information about APs configured in the local database. If the AP Validation is set to RADIUS, information about the APs to be managed by the switch must be added to the external RADIUS database. You can add an AP into the local list of Valid APs from the WLAN > Administration > Basic Setup > Valid AP tab, as the following figure shows, or you can add an AP from the AP Authentication Failures or Rogue AP/RF Scan lists. Field AP Database Managed AP Rogue AP Standalone AP MAC Address Location AP Mode Figure 300: Adding a Valid AP Table 266: Valid Access Point Summary Description Identifies the total number of APs that have been added to the AP database. Identifies the number of APs in the database with an AP Mode set to Managed. Identifies the number of APs in the database with an AP Mode set to Rogue. Identifies the number of APs in the database with an AP Mode set to Standalone. Enter the MAC address of the AP in this field. When you add the MAC address, you add the AP to the local database on the switch. Enter a location to help identify the AP. This field is optional and accepts up to 32 alphanumeric characters, including special characters. This field displays the current mode of the AP, which can be one of the following: • Managed • Standalone • Rogue To configure a different mode, click the MAC address of the AP to go to the Valid Access Point Configuration page. Page 436 Basic Setup Document 34CSFP6XXUWS-SWUM100-D7