D-Link DWS-4026 Product Manual - Page 450

D-Link Unified Access System Software User Manual 12/10/09 The fields in Table 274 on page 450 appear when you click the Debug link for a managed AP on the Managed AP Advanced page. Figure 310: Managed AP Debug Field MAC Address Location IP Address Status Password Confirm Password Enable Debug Table 274: Managed AP Debug Description Shows the MAC address of the access point. Shows the location of the access point, as configured in the Valid AP database. Shows the IP address of the AP. Shows the debug status, which can be one of the following: • None: Debugging has not been enabled or disabled. • Set Requested: A request has been made to change the debug status. • Set Complete: Debugging has been enabled or disabled. Enter the admin password for the AP (the default is admin). Since the password is encrypted, you must retype the password to confirm the password. Select or clear the Enable check box to enable or disable debugging. Once once you Telnet to the AP, you get an AP interface login prompt. The user name is admin. Enter the password you set in the previous field. The default password is admin if you did not specify a new password. From the AP CLI, you can also access the standard Linux prompt by typing the '!' character. You can issue the following debug commands at the Linux OS prompt: • get management: Display management interface information • get managed-ap: Display managed AP information You can issue the following debug commands at the Linux OS prompt: • ifconfig: display all interfaces. • cat /proc/meminfo: View memory utilization Adjusting the Channel and Power Changes you make to the channel and power are runtime changes only. If you change the channel or power settings, the new settings are lost if the AP or switch is reset. The fields in Table 275 on page 451 appear when you click the current channel or power setting for an AP on the Managed AP Advanced page. Page 450 AP Management Document 34CSFP6XXUWS-SWUM100-D7