D-Link DWS-4026 Product Manual - Page 306

D-Link Unified Access System Software User Manual 12/10/09 Figure 212: Create Static Route Entry Field Network Address Subnet Mask Protocol Next Hop IP Address Metric Preference Page 306 Router Figure 213: Create Static Reject Route Entry Table 192: Route Entry Create Fields Description Specify the IP route prefix for the destination from the dropdown menu. In order to create a route, a valid routing interface must exist and the next hop IP Address must be on the same network as the routing interface. Routing interfaces are created on the IP Interface Configuration page. Valid next hop IP Addresses can be viewed on the Route Table page. Also referred to as the subnet/network mask, this indicates the portion of the IP interface address that identifies the attached network. This field tells which protocol created the specified route. Possible values are: • Local • Static • Default • RIP The outgoing router IP address to use when forwarding traffic to the next router (if any) in the path towards the destination. The next router is always one of the adjacent neighbors or the IP address of the local interface for a directly attached network. When creating a route, the next hop IP must be on the same network as the routing interface. Valid next hop IP Addresses can be seen on the 'Route Table' page. Administrative cost of the path to the destination. If no value is entered, default is 1. The range is 0 - 255.This field is present only when creating a static route. Specifies a preference value for the configured next hop. Document 34CSFP6XXUWS-SWUM100-D7