D-Link DWS-4026 Product Manual - Page 67

Software User Manual 12/10/09 D-Link Unified Access System Table 10: Network Connectivity Fields Field Description Protocol Selects the IP protocol version you want to configure on the interface. Depending on your selection, different fields display. Both protocols can be configured. IPv4 Fields: These display when IPv4 is selected as the protocol. IP Address Subnet Mask Default Gateway The IP address of the network interface. The factory default value is 0.0.0.0 Note: Each part of the IP address must start with a number other than zero. For example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid. The IP subnet mask for the interface. The factory default value is 0.0.0.0. The default gateway for the IP interface. The factory default value is 0.0.0.0. Burned-in MAC Address Locally Administered MAC Address This read-only field displays the MAC address that is burned-in to the network card at the factory. This MAC address is used for in-band connectivity if you choose not to configure a locally administered address. You can optionally configure a locally administered MAC address for in-band connectivity instead of using the burned-in universally administered MAC address. In addition to entering an address in this field, you must also set the MAC address type to locally administered. Enter the address as twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0; i.e., byte 0 must have a value between x'40' and x'7F'. MAC Address Type Select the MAC address to use for in-band connectivity. The factory default is to use the burned-in MAC address. • Burned-In: Use the factory default MAC address. • Locally Administered: Use the MAC address you entered in the Locally Administered MAC Address field. Network Configuration Protocol Current Specify what the switch should do following power-up. The factory default is None. The options are as follows: • BootP: Transmit a Bootp request • DHCP: Transmit a DHCP request • None: Do not send any requests following power-up. Management VLAN ID Specifies the management VLAN ID of the switch. The range is 1-3965. The management VLAN is used for management of the switch. This field is configurable for administrative users and read-only for other users. Web Mode Java Mode Controls whether the switch user interface can be accessed from a Web browser. The factory default is enabled. • Enable: Permits Web-based management of the switch. • Disable: Prohibits Web-based management of the switch. If the Web mode is disabled, you must manage the switch by using SNMP or the CLI. Controls whether to display the Java applet that displays a picture of the switch at the top right of the screen. The factory default is enabled: • Enable: Permits the applet to display. The Java applet lets click on the picture of the switch to select configuration screens instead of using the navigation tree at the left side of the screen. • Disable: Does not allow the Java applet to display. The applet is replaced by a blank area. Document 34CSFP6XXUWS-SWUM100-D7 IP Address Page 67