D-Link DWS-4026 Product Manual - Page 499

Software User Manual 12/10/09 D-Link Unified Access System Table 320: Detected Client Pre-Authentication History Field Description MAC Address MAC address of the client. AP MAC Address MAC Address of the managed AP to which the client has pre-authenticated. Radio Interface Number Radio number to which the client is authenticated, which is either Radio 1 or Radio 2. VAP MAC Address SSID Age VAP MAC address to which the client roamed. SSID Name used by the VAP. Time since the history entry was added. User Name Pre-Authentication Status Indicates the user name of client that authenticated via 802.1X. Indicates whether the client successfully authenticated and shows a status of Success or Failure. Viewing Detected Client Triangulation The Detected Client Triangulation page lists up to three non-sentry and three sentry managed APs that have detected the client. The signal strength reported by the APs can help triangulate the location of the client. Since an AP can have one radio configured in sentry mode and another radio configured in non-sentry mode, the same AP might appear in both lists. If the AP or the Client has not been detected by three APs, the list can contain zero, one or two entries. Figure 344: Detected Client Triangulation Table 321 describes the fields on the Detected Client Triangulation page. Field Detected Client MAC Address Sentry MAC Address Radio RSSI Table 321: Detected Client Triangulation Description MAC address of the client. Identifies whether the radio that detected the client is in sentry or non-sentry mode. • Non-Sentry: The radio that detected the client is not configured in sentry mode. This means the radio can accept connections from wireless clients and send and receive traffic • Sentry: The radio that detected the client is configured in sentry mode. Networks that deploy sentry APs or radios can detect devices on the network quicker and perform more thorough security analysis. MAC Address of the managed AP that detected the client. Radio number to which the client is authenticated, which is either Radio 1 or Radio 2. Received signal strength indicator in terms of percentage for the non-sentry AP. The range is 0-100, where the maximum value is 100. A value of 0 indicates that the client is not detected. Document 34CSFP6XXUWS-SWUM100-D7 Monitoring and Managing Intrusion Detection Page 499