D-Link DWS-4026 Product Manual - Page 296

D-Link Unified Access System Software User Manual 12/10/09 Figure 202: RIP Interface Authentication Configuration 5 Select the type of authentication to use. If you select Simple or Encrypt as the authentication, the screen refreshes, and additional fields display. Enter the required information into the new fields. 6 Click Submit to apply the changes to the system and return to the RIP Interface Configuration page. 7 To cancel the authentication configuration and return to the RIP Interface Configuration page, click Cancel. RIP INTERFACE SUMMARY Use the RIP Interface Summary page to display RIP configuration status on an interface. To display the page, click LAN > Monitoring > L3 Status > RIP > Interface Summary in the navigation tree. Field Slot/Port IP Address Send Version Figure 203: RIP Interface Summary Table 184: RIP Interface Summary Fields Description The interface, such as the routing-enabled VLAN on which RIP is enabled. The IP Address of the router interface. Specifies the RIP version to which RIP control packets sent from the interface conform. The default is RIP-2. Possible values are: • RIP-1: RIP version 1 packets are sent using broadcast. • RIP-1c: RIP version 1 compatibility mode. RIP version 2 formatted packets are transmitted using broadcast. • RIP-2: RIP version 2 packets are sent using multicast. • None: RIP control packets are not transmitted. Page 296 Configuring RIP Document 34CSFP6XXUWS-SWUM100-D7